​The correct operation of electronic crane scales can avoid safety hazards

The correct operation of electronic crane scales can avoid safety hazards
 In daily life, we can see a variety of scales in many places. Especially the electronic crane scale, its use is very extensive. You can see it in a lot of places, it's a measuring device, it's an instrument that we use to weigh things. Most of them are used in supermarkets, markets and all kinds of food stores. It is to weigh the articles on the prescribed scales. Is very convenient.
 Of course, there are many kinds of it, and its principles and USES vary. Explosion-proof electronic scale is one of them, it is mainly used to avoid the weight of objects and will scale broken. This function is very characteristic, it is mostly used to give a lot of overweight objects, more human scale. Most of the time it's used in factories.
 All the time, safety is something we are very concerned about, for the electronic crane scale is the same, only safety can be smooth production, when using the electronic crane scale must be safe in * position. Many operators do not operate the electronic crane scale correctly, so it leads to some safety problems, so careful operation of the electronic crane scale is the most critical.
 First, the electronic crane scale before use, should be the corresponding battery into the scale body and handheld.
 When installing or replacing the battery, tighten the lock screw of the battery clip, check whether the battery clip is firmly fixed on the scale body, and then close the door of the crane scale to prevent accidents. When the meter shows low voltage, the battery pack should be replaced immediately and the replaced battery should be charged in time to prevent battery damage. When the battery pack is not in use for a long time, it should be recharged at regular intervals. The battery should be stored in a dry and ventilated environment with appropriate temperature, and avoid contact with corrosive substances. When loading and unloading battery pack connection line aviation socket, do not use  the hand to grasp the clamp wire cap clamping wires, and should grasp the base, on the other side of the transmitter on the aviation plug also do not grasp the clamp wire cap, should grasp the head of the rotating cap loading and unloading, prevent the power connection loose, cause trouble. Before the transmitter is connected to the power supply, the antenna and its feeder must be connected reliably, otherwise the transmitter will be damaged.
 Two, avoid electronic crane scale by violent pull and collision.
 Electronic crane scale inside many electronic components, such as integrated circuit, quartz crystal, sensors, monitors, etc., when there is intense collision of electronic crane scale, can damage the components, electronic scale caused by fault, affect accuracy so as to affect the normal use, and other items to avoid scale body collision or falling from high up in the air, instrument to should take put down gently, don't put randomly, to prevent unnecessary loss, the instrument fixed on the crane should be taken when using vibration reduction measures, so as not to affect the reliability.
 Three, can not be arbitrarily dismantled but electronic crane scales on the parts.
 In the normal use of electronic crane scale, do not remove the electronic scale parts, do not open the seal on the sensor, remove the integrated circuit and other components on the instrument, necessary maintenance, must be under the guidance of the relevant technical personnel or have a certain maintenance knowledge, to prevent the expansion of the fault.
 So the operation of electronic crane scale must pay attention to the above matters, so as to better work.