​Introduction to the installation of electronic crane scales

Keyword:electronic crane scales   Time:2019-11-13 10:05:37

Introduction to the installation of electronic crane scales

 The installation of the electronic crane scale is related to the use of the electronic crane scale, the installation of some details of the electronic crane scale, is also very important, to this problem, we introduce the following.

 A. Structure and installation of electronic crane scale.

When the product leaves the factory, the mechanical part of the scale body (hook, ring load-bearing mechanism, sensor and other important parts) shall be  installed and adjusted by the manufacturer. Please do not disassemble!

 B.  Installation instructions for battery of electronic crane scale:

 The battery is installed in the back cover (the cover plate with antenna and switch is the front cover, and the cover plate with the company's nameplate is the  back cover). When replacing the battery, unscrew two M8 inner hexagon screws, open the battery cover, put the new battery into the back cover after matching, and then tighten the screw.

 C.  Installation of launcher:

 Remove the front cover and install the data acquisition board and the launch board in the corresponding position.

 Attention should be paid to the installation and printing equipment of electronic crane scales:

 Electronic crane scale in use, you can install printing equipment, such goods in the suspension state, can also be directly printed, do not need to use other printing equipment to operate, so electronic crane scale for the installation of printing equipment what requirements? First, print at a familiar height of at least two millimeters, so that the printed content will be more clear and durable. Second, print the unit name or symbol, which must be after the value, or above the value of a column, so that it can be easily seen.

 If the balance is not stable, you must stop printing, and the printed data cannot be used. If you want to print again, you must make the balance of the electronic crane balance stable, and the print value also need to be fixed, so that you can print. So the hook scale can also be like electronic crane scales like the installation of printing equipment? Yes, hook scale and electronic crane scale work in the same nature, can also be hung on the weighing of goods, so when installing printing equipment, you can refer to the requirements of electronic crane scale.

 These aspects, can not be ignored, are to ensure the normal operation of electronic crane scale necessary measures.

 Electronic crane scales in use, should be the corresponding battery into the scale body and handheld.

 When installing or replacing the battery, tighten the lock screw of the battery clip, check whether the battery clip is firmly fixed on the scale body, and then close the door of the crane scale to prevent accidents. When the meter shows low voltage, the battery pack should be replaced immediately and the replaced battery should be charged in time to prevent battery damage. When the battery pack is not in use for a long time, it should be recharged at regular intervals. The battery should be stored in a dry and ventilated environment with appropriate temperature, and avoid contact with corrosive substances. When loading and unloading battery pack connection line aviation socket, do not use the hand to grasp the clamp wire cap clamping wires, and should grasp the base, on the other side of the transmitter on the aviation plug also do not grasp the clamp wire cap, should grasp the head of the rotating cap loading and unloading, prevent the power connection loose, cause trouble. Before the transmitter is connected to the power supply, the antenna and its feeder must be connected reliably, otherwise the transmitter will be damaged.


Crane Scales7.jpg

Ramhoist News
  • No information
Ramhoist FAQ