1 Ton Electric Pallet Stacker Rider Walkie Type Electric Battery Forklift

Specification for the Use of Electric pallet stacker in Enterprises
 I.Intention: To enable warehouse managers to understand the characteristics and structure of all-electric pallet stacker elevator, master the operation process of all-electric pallet stacker elevator, matters needing attention, routine maintenance, etc.            
 II. Manipulation method:
 1.Warehouse keeper understands that RAMHOIST stacker truck must be on the open garden ground. It can only be used on the first and second floor of the shelf after basic understanding. Only after one month of understanding, can the warehouse keeper manipulate three, four and five layers of cargo deposit.           
 1.  Electric pallet stacker launching: check to ensure that the battery is charged  and overcharged, and the indicator light is on. Put the key into the lock, turn it clockwise, and lift the emergency stop switch to launch the RAMHOIST pallet stacker.           
 2.  Forward/Evacuation of Electric Pallet stacker Truck: Pull the control handle of  this china Pallet stacker Truck to its own wall and swing down an inappropriate viewpoint. (Leaving the vertical position but not the lowest position), then turn two knob switches with thumb: If the switch is turned forward, the pallet stacker truck will move forward, if the switch is turned backward, the pallet  stacker truck will withdraw. Departure. The forward/evacuation rate is controlled by the turning viewpoint size of the knob switch. In order to ensure safety, the turning viewpoint should be controlled a little smaller at the time of initiation or when the surrounding space is small, so as to ease the forward speed. The handle has a low-speed button and pushes it to a minimum of low-speed advance.           
 3.  The fork landing of electric pallet stacker truck: press the button with the  pick-up mark on the control handle with your finger, the fork will rise; press the button with the drop mark, the fork will land; and immediately start to rise and fall after release.           
 4.  Belly safety finally: When the RAMHOIST stacker truck evacuates, if the body collides with the red belly switch, the truck will start immediately and stand a short distance backward toward the forward target, which is important to prevent your figure from being kneaded.             

 5. Routine parking of stacking truck: When you need to bump parking of stacking truck, release your thumb and  reset the torsion switch automatically. At this time, the reverse current will occur through the controller, and the stacking truck will stop bumping after resting for a very small distance.           
 6.  Vehicle Charging: When the meter gives a flashing signal, i.e. "power  exhaustion" alarm, it should be charged in real time. When charging, the lock should be closed and the key inserted from the lock.           
 III.  Manipulating the process of loading:           
 1.  Move the stacking truck in front of the heavy objects.           
 2.  Raise the fork to an inappropriate height below the bottom of the weight.           
 3. Move the pallet stacker forward so that the fork reaches below the weight.            

 4. Lift the fork until the weight is loaded.           
 5.  The pallet stacker truck moves back together with the weight until the fork has  landing space.           
 6.  Slowly drop the weight to the inappropriate height.           
 IV.  Loading process:           
 1.  Move the heap truck with heavy load to the front of the shelf.           
 2.  Promote the weight to the height of improper;           
 3.  Forward moving stack truck to the wrong direction;           
 4.  Slowly landing heavy objects, so that the lower bottom of the heavy pallet is sitting on the shelf;           
 5.  Slowly move the stacking truck out of the shelf with its fork.